Compressed air products

Filter / regulators

9.4.11

Optional extras

Tamper-proof cap

Pressure gauges for panel mounting

An aluminium tamper-proof cap can be fitted to prevent unauthorised

pressure adjustment.

With chromium plated bezel available in two ranges, the face being

marked in bar and psi as follows:-

Dimensions (approximate) in mm

53

A plated mild steel bracket which can be attached to the filter/

regulator by the plastic mounting ring supplied.

Note: An aluminium mounting ring can be supplied at extra cost, and

must be specified, if required, on order placement.

Dimensions (approximate) in mm

A

B

C

D

E

44

19

32

12

6

If the regulator is to be panel mounted a hole is required in the panel

48 mm diameter, and the panel thickness must not exceed 8 mm.

Pressure ranges

0 to 2 bar

0 to 11 bar

0 to 30 psi

0 to 160 psi

54

Dimensions (approximate) in mm

A

B

C

D

53

56

48

R

Type 21 mounting bracket

D

Clamping yoke

B

A

C

D

C

B

A

Mounting ring

Discharge tube adaptor IP2AM only

An adaptor can be supplied for the auto-drain on the IP2AM models,

to accept 8 mm O/D copper or plastic tube.

E

Metal bowl

with sight level

Pressure gauge

Available in two sizes, with 4 pressure ranges. The face is marked

in both bar and psi. Please state, size and pressure range when

placing an order.

Pressure ranges

0 to 2 bar

0 to 7 bar

0 to 11 bar

0 to 20 bar

0 to 30 psi

0 to 100 psi

0 to 160 psi

0 to 300 psi (2" size only)

Bowl guard

Dimensions (approximate) in mm

Size

A

B

11⁄2"

40

47

R"

2"

49

45

R"

In the interest of safety Spirax Sarco recommend that a bowl guard

should be fitted to polycarbonate bowls - see the 'Warning'

under 'Safety information, installation and maintenance' page 5.

C

A

C

B

TI-P504-17 CH Issue 2 IP2, IP2A and IP2D Spirax-Monnier International Compressed Air Filter / Regulators Page 2 of 6