Take care

of your flooring

The Evolution range floors have a polyurethane treatment

that protects the surfaces, reducing the need for cleaning cited

in the maintenance regime, with consequent advantages

in terms of costs and environmental protection.

The instructions of maintenance reported below

are designed to minimize costs without in the long term

compromising the aesthetic appearance of the floor.

Once completed the installation, (if glued you must not step

on the floor for 24 hours until the glue has not dried) proceed

in this way:

- if glued, remove debris and make sure that all of dried glue

has been removed from the floor surface

- sweep or pass the floor with vacuum cleaner to remove

dust and debris

- pass on the floor with a rag wet microfiber and a low foaming

cleaner (detergent EVO).

The recommendations given below serve as guidelines

and the frequency of cleaning operations can be changed

to optimize the appearance of the floor.

Daily operations

- Sweep or pass the floor with a vacuum cleaner to remove

dust and dirt.

- If necessary, remove tracks and resistant stains with a low-

foaming alkaline cleaner (detergent EVO).

Weekly/monthly operations

- Sweep or pass the floor with a vacuum cleaner

to remove dust and dirt.

- If necessary, the glued products can be cleaned

with a scrubber equipped with special bearings and a low

foam alkaline detergent. If you do not have a device, pass

on the floor with a rag in a damp microfiber and a low foam

alkaline detergent (detergent EVO).

CLEANING WITH AUTO SCRUBBER, ROTOCLEANER

OR SINGLE-BRUSH MACHINE

CAUTION: Make sure that the machine is used efficiently

and immediately removes water and detergent.

Periodic cleaning (1 time per week):

- use discs for normal maintenance type 3M red.

- neutral detergent suitable for PVC floors, alkaline low foam

suitable for the thorough cleaning of the “detergent EVO”.

- do not use abrasive disks or any procedure that risks

damaging the surface (PU surface).

REMOVING / CLEANING DIFFICULT STAINS

Paints: do not use abrasive sponges or steel wool,

use specific solvent for paint if it is known. After removing

the stain, rinse well with water.

Acrylic adhesives: apply water with detergent, leave

for a few minutes and then remove. If the stain persists apply

pure detergent, leave for a few minutes and then rinse.

Rubber marks/shoes: apply pure detergent, leave it on for five

minutes, scrub, rinse with plenty of water.

MANUTENZIONE | MAINTENANCE | 81